Stucco expansion joints are generally .75″ wide, and .5″ deep, so they should not be too bold. Color is usually the same as the adjacent walls. These should only be “cheat modeled” with splines if the camera is far enough away to not tell the difference. Care should be taken when reading cad elevations. Do […]
Window “pop-outs” generally project out 2 inches from the face of the building. Sometimes at the top or bottom of the window, we might have a horizontal base or header, and often these are pushed out an additional 2″ (total of 4″ off the facade). Long horizontal accent bands which often span the length of
No gaps or holes should exist unless shown in the DWGs. These are commonly found under buildings, or at bottoms of doors. Fill in the “ground” and/or move the geometry as needed.
If you see any unusual elements or objects on a building, check the drawings to see if it exists and if it should be visible. Sometimes hidden lines in the cad end up visible in the 3D model.